|
SALIENT FEATURES OF COMPRESSED REFRIGERATED AIR DRYERS
» Compact Design
» Low Pressure Drop
» Consistent Dew Point
» Power Saving
» High Quality Finishing
» Non-cyclic System
» More Reliability
» Ease of Installation
» Environment Friendly
» Reduced Maintenance
UNIQUE CO-EX HEAT EXCHANGERS
Our CO-EX Exchanger is a COAXIAL Heat Exchanger. It performs as
a Precooler and Evaporator. Our design maximizes exchanger efficiency
by using Copper tubes in a coiled TUBE-IN-TUBE arrangement. Tube
sizes are carefully chosen so that fluid velocities are maintained
through the tubes. This promotes turbulence break up boundary and
maximizes the heat transfer rate with minimum pressure drop. To
further increase heat transfer efficiency, a Counter Flow pattern
is used that achieves the maximum temperature difference. In addition,
exchangers are fully encapsulated by PUF insulation to prevent the
loss of cooling effect.
SPECIAL FEATURE OF CO-EX
- Full copper corrosion free heat exchanger.
- Non-fouling exchanger.
- Co-Axial arrangement, tends to minimize space requirement.
- Minimises power consumption
- No leakage.
- Low pressure drop.
- High efficiency
MOISTURE SEPARATOR
Cyclonic / centrifugal type moisture seperator specifically developed
by GEM for condensate removal in 2KD+ Series Dryers. Designed to
achieve the highest separation efficiency and maintain this efficiency
from low flows to well above the rated capacity.
Efficient separation ensures that liquid condensed in the Evaporator
is not carried over by the outlet air, avoids raising the outlet
Dew Point. Separator is encapsulated within PUF insulation to prevent
re-heating of air before separation occurs.
DEPENDABLE AUTOMATIC CONDENSATE DRAIN WITH THE FOLLOWING FEATURES:
Adjustable electronic timer controlled, Pilot operated, compressed
air powered, Auto drain valve. Positive discharge of even heavily
contaminated condensate.
NON-CYCLIC REFRIGERATION SYSTEM:
HOT GAS BY-PASS Value automatically maintains temperature across
a wide range and ambient conditions without the need any adjustments.
High pressure by-pass refrigerant gas is introduced after the expansion
value to ensure temperature control. Direct expansion, non-cycling
allows rapid response to changes in operating conditions.
EASE OF INSTALLATION:
All dryers are shipped pre-piped and wired, ready to install and
operate, installation is made easy with conveniently located Air
and Drain connections.
ELECTRICAL:
In accordance with applicable codes Compressors are protected with
overloads and safety trips.
ENVIRONMENTAL:
GEM DRYERS are designed for low energy usage, helping to conserve
the Earth's Resources and minimize pollution. Refrigerants are with
low ozone depletion factor, and thereby making GEM dryers’ ‘OZONE
FRIENDLY’.
SERVICE:
GEM DRYERS are designed to require little maintenance. Should service
be necessary, a team of trained technicians is available to answer
your questions about installation, operation and maintenance or
repair. A complete inventory of spare parts is maintained at the
factory and channel partners & local service providers located all
over India.
|
